You copied the Doc URL to your clipboard.

B.1. Mechanical information

Figure B.1 shows the dimensions for the connectors on the top side of the board. See Table B.1 for details on connector type, part numbers, and manufacturers.

Figure B.1. Board dimensions (top view)

Board dimensions (top view)

The Integrator/IM-AD1 is designed to be stackable (as the top card). Figure B.2 shows the dimensions for the connectors on the bottom side of the board as viewed from the top side of the board. These connectors carry the signals between the IM-AD1 and the logic module. (All dimensions are in mm.)

Figure B.2. Bottom board dimensions (viewed from top side)

Bottom board dimensions (viewed from top side)
Was this page helpful? Yes No