You copied the Doc URL to your clipboard.

13.15 B



B{cond}{.W} label



is an optional condition code.


is an optional instruction width specifier to force the use of a 32-bit B instruction in T32.


is a PC-relative expression.


The B instruction causes a branch to label.

Instruction availability and branch ranges

The following table shows the branch ranges that are available in A32 and T32 code. Instructions that are not shown in this table are not available.

Table 13-4 B instruction availability and range

Instruction A32 T32, 16-bit encoding T32, 32-bit encoding
B label ±32MB ±2KB ±16MB a
B{cond} label ±32MB –252 to +258 ±1MB a

Extending branch ranges

Machine-level B instructions haverestricted ranges from the address of the current instruction. However,you can use these instructions even if label isout of range. Often you do not know where the linker places label.When necessary, the linker adds code to enable longer branches. Theadded code is called a veneer.

B in T32

You can use the .W width specifier to force B to generate a 32-bit instruction in T32 code.

B.W always generates a 32-bit instruction, even if the target could be reached using a 16-bit instruction.

For forward references, B without .W always generates a 16-bit instruction in T32 code, even if that results in failure for a target that could be reached using a 32-bit T32 instruction.

Condition flags

The B instruction does not changethe flags.


See the earlier table for details of availability of the B instruction.


    B       loopA

Related reference


Use .W to instruct the assembler to use this 32-bit instruction.