You copied the Doc URL to your clipboard.

MCR and MCR2

Move to Coprocessor from general-purpose register. Depending on the coprocessor, you might be able to specify various additional operations.

Note

MCR2 is not supported in Arm®v8.

Syntax

MCR{cond} coproc, #opcode1, Rt, CRn, CRm{, #opcode2}

MCR2{cond} coproc, #opcode1, Rt, CRn, CRm{, #opcode2}

where:

cond

is an optional condition code.

In A32 code, cond is not permitted for MCR2.

coproc

is the name of the coprocessor the instruction is for. The standard name is pn, where n is an integer whose value must be:

  • In the range 0-15 in Armv7 and earlier.
  • 14 or 15 in Armv8.
opcode1
is a 3-bit coprocessor-specific opcode.
opcode2
is an optional 3-bit coprocessor-specific opcode.
Rt
is a general-purpose register. Rt must not be PC.
CRn, CRm
are coprocessor registers.

Usage

The use of these instructions depends on the coprocessor. See the coprocessor documentation for details.

Architectures

These 32-bit instructions are available in A32 and T32.

There are no 16-bit versions of these instructions in T32.

Was this page helpful? Yes No