You copied the Doc URL to your clipboard.

UXTL, UXTL2 (vector)

Unsigned extend Long.

This instruction is an alias of USHLL, USHLL2.

The equivalent instruction is USHLL{2} Vd.Ta, Vn.Tb, #0.

Syntax

UXTL{2} Vd.Ta, Vn.Tb

Where:

2
Is the second and upper half specifier. If present it causes the operation to be performed on the upper 64 bits of the registers holding the narrower elements. See <Q> in the Usage table.
Vd
Is the name of the SIMD and FP destination register.
Ta
Is an arrangement specifier, and can be one of the values shown in Usage.
Vn
Is the name of the SIMD and FP source register.
Tb
Is an arrangement specifier, and can be one of the values shown in Usage.

Usage

Unsigned extend Long. This instruction copies each vector element from the lower or upper half of the source SIMD and FP register into a vector, and writes the vector to the destination SIMD and FP register. The destination vector elements are twice as long as the source vector elements.

The UXTL instruction extracts vector elements from the lower half of the source register, while the UXTL2 instruction extracts vector elements from the upper half of the source register.

Depending on the settings in the CPACR_EL1, CPTR_EL2, and CPTR_EL3 registers, and the current Security state and Exception level, an attempt to execute the instruction might be trapped.

The following table shows the valid specifier combinations:

Table 20-117 UXTL, UXTL2 (Vector) specifier combinations

<Q> Ta Tb
- 8H 8B
2 8H 16B
- 4S 4H
2 4S 8H
- 2D 2S
2 2D 4S
Was this page helpful? Yes No