You copied the Doc URL to your clipboard.

LSR

Logical Shift Right. This instruction is a preferred synonym for MOV instructions with shifted register operands.

Syntax

LSR{S}{cond} Rd, Rm, Rs

LSR{S}{cond} Rd, Rm, #sh

where:

S
is an optional suffix. If S is specified, the condition flags are updated on the result of the operation.
Rd
is the destination register.
Rm
is the register holding the first operand. This operand is shifted right.
Rs
is a register holding a shift value to apply to the value in Rm. Only the least significant byte is used.
sh
is a constant shift. The range of values permitted is 1-32.

Operation

LSR provides the unsigned value of a register divided by a variable power of two, inserting zeros into the vacated bit positions.

Restrictions in T32 code

T32 instructions must not use PC or SP.

Use of SP and PC in A32 instructions

You can use SP in these A32 instructions but they are deprecated.

You cannot use PC in instructions with the LSR{S}{cond} Rd, Rm, Rs syntax. You can use PC for Rd and Rm in the other syntax, but this is deprecated.

If you use PC as Rm, the value used is the address of the instruction plus 8.

If you use PC as Rd:

  • Execution branches to the address corresponding to the result.
  • If you use the S suffix, the SPSR of the current mode is copied to the CPSR. You can use this to return from exceptions.

    Note

    The A32 instruction LSRS{cond} pc,Rm,#sh always disassembles to the preferred form MOVS{cond} pc,Rm{,shift}.

CAUTION:

Do not use the S suffix when using PC as Rd in User mode or System mode. The assembler cannot warn you about this because it has no information about what the processor mode is likely to be at execution time.

You cannot use PC for Rd or any operand in the LSR instruction if it has a register-controlled shift.

Condition flags

If S is specified, the instruction updates the N and Z flags according to the result.

The C flag is unaffected if the shift value is 0. Otherwise, the C flag is updated to the last bit shifted out.

16-bit instructions

The following forms of these instructions are available in T32 code, and are 16-bit instructions:

LSRS Rd, Rm, #sh
Rd and Rm must both be Lo registers. This form can only be used outside an IT block.
LSR{cond} Rd, Rm, #sh
Rd and Rm must both be Lo registers. This form can only be used inside an IT block.
LSRS Rd, Rd, Rs
Rd and Rs must both be Lo registers. This form can only be used outside an IT block.
LSR{cond} Rd, Rd, Rs
Rd and Rs must both be Lo registers. This form can only be used inside an IT block.

Architectures

This 32-bit instruction is available in A32 and T32.

This 16-bit T32 instruction is available in T32.

Example

    LSR     r4, r5, r6
Was this page helpful? Yes No