You copied the Doc URL to your clipboard.

Saturating instructions

Some A32 and T32 instructions perform saturating arithmetic.

The saturating instructions are:

  • QADD.

  • QDADD.

  • QDSUB.

  • QSUB.

  • SSAT.

  • USAT.

Some of the parallel instructions are also saturating.

Saturating arithmetic

Saturation means that, for some value of 2n that depends on the instruction:

  • For a signed saturating operation, if the full result would be less than -2n, the result returned is -2n.

  • For an unsigned saturating operation, if the full result would be negative, the result returned is zero.

  • If the full result would be greater than 2n-1, the result returned is 2n-1.

When any of these occurs, it is called saturation. Some instructions set the Q flag when saturation occurs.

Note

Saturating instructions do not clear the Q flag when saturation does not occur. To clear the Q flag, use an MSR instruction.

The Q flag can also be set by two other instructions, but these instructions do not saturate.

Was this page helpful? Yes No