You copied the Doc URL to your clipboard.

SQDMLAL (scalar)

Signed saturating Doubling Multiply-Add Long.

Syntax

SQDMLAL Vad, Vbn, Vbm

Where:

Va
Is the destination width specifier, and can be either S or D.
d
Is the number of the SIMD and FP destination register.
Vb
Is the source width specifier, and can be either H or S.
n
Is the number of the first SIMD and FP source register.
m
Is the number of the second SIMD and FP source register.

Usage

Signed saturating Doubling Multiply-Add Long. This instruction multiplies corresponding signed integer values in the lower or upper half of the vectors of the two source SIMD and FP registers, doubles the results, and accumulates the final results with the vector elements of the destination SIMD and FP register. The destination vector elements are twice as long as the elements that are multiplied.

If overflow occurs with any of the results, those results are saturated. If saturation occurs, the cumulative saturation bit FPSR.QC is set.

The SQDMLAL instruction extracts each source vector from the lower half of each source register, while the SQDMLAL2 instruction extracts each source vector from the upper half of each source register.

Depending on the settings in the CPACR_EL1, CPTR_EL2, and CPTR_EL3 registers, and the current Security state and Exception level, an attempt to execute the instruction might be trapped.

The following table shows the valid specifier combinations:

Table 19-13 SQDMLAL (Scalar) specifier combinations

Va Vb
S H
D S
Was this page helpful? Yes No