You copied the Doc URL to your clipboard.

UQXTN (scalar)

Unsigned saturating extract Narrow.

Syntax

UQXTN Vbd, Van

Where:

Vb
Is the destination width specifier, and can be one of the values shown in Usage.
d
Is the number of the SIMD and FP destination register.
Va
Is the source width specifier, and can be one of the values shown in Usage.
n
Is the number of the SIMD and FP source register.

Usage

Unsigned saturating extract Narrow. This instruction reads each vector element from the source SIMD and FP register, saturates each value to half the original width, places the result into a vector, and writes the vector to the destination SIMD and FP register. All the values in this instruction are unsigned integer values.

If saturation occurs, the cumulative saturation bit FPSR.QC is set.

The UQXTN instruction writes the vector to the lower half of the destination register and clears the upper half, while the UQXTN2 instruction writes the vector to the upper half of the destination register without affecting the other bits of the register.

Depending on the settings in the CPACR_EL1, CPTR_EL2, and CPTR_EL3 registers, and the current Security state and Exception level, an attempt to execute the instruction might be trapped.

The following table shows the valid specifier combinations:

Table 19-34 UQXTN (Scalar) specifier combinations

Vb Va
B H
H S
S D
Was this page helpful? Yes No