Load addresses to a register using ADRL
ADRL pseudo-instruction loads an address within a certain range, without performing a data load. The range is wider than that of the
ADRL accepts a PC-relative expression, that is, a label with an optional
offset where the address of the label is relative to the current PC.
The label used with
ADRL must be
within the same code section. The assembler faults references to
labels that are out of range in the same section.
The assembler converts an
ADRL r pseudo-instruction
- Two data processing instructions that load the address, if it is in range.
- An error message if the address cannot be constructed in two instructions.
The available range depends on the instruction set and encoding.
Any value that can be generated by two
SUBinstructions. That is, any value that can be produced by the addition of two values, each of which is 8 bits rotated right by any even number of bits within a 32-bit word. The range is relative to the PC.
- 32-bit T32 encoding
±1MB to a byte, halfword, or word-aligned address.
- 16-bit T32 encoding
ADRLis not available.