You copied the Doc URL to your clipboard.

Arm Cortex‑M1 DesignStart FPGA-Xilinx edition User Guide : Installing Arm IP repository

Installing Arm IP repository

After downloading and unpacking the deliverable, the Arm IP Integrator (IPI) repository must be added to the list of Vivado IP repositories. This makes the processor available in any new designs.

To add Arm IPI repository to the list of Vivado IP repositories:

Prerequisites

You must complete the steps in:

Procedure

  1. Open Vivado.
  2. From Tools → Settings, select IP Defaults.
  3. In the list of Default IP repository search paths, add the path to the /Arm_ipi_repository.

    Vivado only reads the IPI repository during design creation. If the repository is updated, or an existing design must use the Cortex®‑M1 processor, then you must refresh the project repository. To do this, navigate to Tools → Settings → IP → Repository → Refresh all.

Next Steps

You must now proceed to Installing Arm software repository.

Was this page helpful? Yes No