You copied the Doc URL to your clipboard.

Using the μVision debugger to communicate through V2C-DAPLink

To set up a μVision project to communicate through V2C-DAPLink:


  1. Load the project and then go to Options for Target <name of executable> (alt+F7).
  2. Select the Debug tab.
  3. On the right-hand side of the screen deselect Load Application at Startup.
  4. Select Use:, and then select CMSIS-DAP Debugger from the drop-down menu.

    Figure 5-4 Debug tab

  5. Click Settings and select the subsequent Debug tab.

    Figure 5-5 Debug tab

  6. Ensure that SWJ is ticked and select CMSIS-DAP from the drop-down menu. The IDCODE must read a valid value and the device name must indicate ARM Core Sight SW-DP.
  7. Click OK in the Cortex-M Target Driver Setup and Options for Target <name of executable> screens.
  8. You can now connect the debugger to the target by clicking on the debug icon.

    Figure 5-6 Debug icon

Was this page helpful? Yes No