You copied the Doc URL to your clipboard.

TCU tie-off signals

The TCU tie-off signals are sampled at reset. Ensure that the value of these signals does not change when the LPI_PD interface is not in Q_STOPPED state.

The following table shows the TCU tie-off signals.

Table A-10 TCU tie-off signals

Signal

Direction

Description

sup_cohacc

Input

This signal indicates whether the QTW interface is I/O-coherent. Tie HIGH when the TCU is connected to a coherent interconnect.

sup_btm

Input

This signal indicates whether the Broadcast TLB Maintenance is supported. Tie HIGH when the TCU is connected to an interconnect that supports DVM.

sup_sev

Input

This signal indicates whether the Send Event mechanism is supported. Tie HIGH when evento is connected.

sup_oas[2:0]

Input

Output address size supported.

The encodings for this input are:

0b00032 bits.
0b00136 bits.
0b01040 bits.
0b01142 bits.
0b10044 bits.
0b10148 bits.

You must not use other encodings, including 0b110 that SMMUv3.1 defines to indicate 52-bit addresses. They are treated as 0b101.

sec_override Input When HIGH, certain registers are accessible to Non-secure accesses from reset, as the TCU_SCR register settings describe.
ecorevnum[3:0] Input Tie this signal to 0 unless directed otherwise by Arm.

See the Arm® System Memory Management Unit Architecture Specification, SMMU architecture version 3.0 for more information about the SMMUv3 ID signals.

Was this page helpful? Yes No