You copied the Doc URL to your clipboard.

Debug and trace interface

The Arm debug and trace interface enables powerful software debug and optimization on an Arm® processor-based target system. It is based on the IEEE 1149.1 (JTAG) interface coupled with various additional signals. This chapter introduces these signals and describes their use within the interface.


  • Unless otherwise specified, all pull-up/pull-down resistors that are discussed in this chapter must be between 1K and 100K (10K is recommended).
  • Unless otherwise specified, any signals beginning with a lowercase 'n' are, by default, active-LOW.

It contains the following sections:

Was this page helpful? Yes No