You copied the Doc URL to your clipboard.

Debug Configurations - Environment tab

Use the Environment tab in the Debug Configurations dialog box to create and configure the target environment variables that are passed to the application when the debug session starts.

The Environment tab contains the following elements:

Note

The settings in this tab are not used for connections that use the Connect to already running gdbserver debug operation.
Target environment variables to set

This panel displays the target environment variables in use by the debugger.

New...

Opens the New Environment Variable dialog box where you can create a new target environment variable.

For example, to debug the Gnometris application on a model you must create a target environment variable for the DISPLAY setting.

Figure 11-66 New Environment Variable dialog box

New Environment Variable dialog box

Edit...

Opens the Edit Environment Variable dialog box where you can edit the properties for the selected target environment variable.

Remove

Removes the selected target environment variables from the list.

Apply

Save the current configuration. This does not connect to the target.

Revert

Undo any changes and revert to the last saved configuration.

Debug

Connect to the target and close the Debug Configurations dialog box.

Close

Close the Debug Configurations dialog box.

Figure 11-67 Environment tab (Shown with environment variables configured for an FVP)

Environment tab (Shown with environment variables configured for an FVP) )

Was this page helpful? Yes No