You copied the Doc URL to your clipboard.

Trace Dump dialog box

Use the Trace Dump dialog box to generate an output file containing the encoded trace data from the buffer. You can also specify for metadata files to be created, which describe the trace sources that produced that data.

Select Trace Capture Device

Select the trace capture device which should have its data dumped.

Select Trace Source

Select the trace source which should have its data dumped. You can select multiple sources.

Raw Dump for Devices

If selected, dump the data retrieved from RDDI, including any device-specific formatting.

If unselected, provides the target data captured in a format suitable for export. Typically, this is 16-byte CoreSight frames with full frame syncs removed.

Dump Trace and Metadata

Dump both the trace data and the metadata.

Dump Trace Only

Dump the trace data only.

Dump Metadata Only

Dump the metadata only.

Base Directory
Full path to the base directory to write the output to.
Dump Directory

New directory to create within the Base Directory. The dump output is printed within this directory.

Split Output Files

Maximum output file size before the output is split and written to multiple files.

Available options:

  • Split Files at 1MB.

  • Split Files at 32MB (FAT limit).

  • Split Files at 512MB.

  • Split Files at 1GB (default).

  • Split Files at 2GB (FAT16 limit).

  • Split Files at 4GB (FAT32 limit).

Help

Open the Show Contextual Help dialog.

OK

Accept the current configure options and create the Trace Dump file.

Cancel

Exit the Trace Dump dialog.

Reset defaults

Reset all configuration options to their default values.

Figure 11-54 Trace Dump dialog box

Trace Dump dialog box

Was this page helpful? Yes No