You copied the Doc URL to your clipboard.

GenericTimer component

This section describes the GenericTimer component.

CounterModule component

This section describes the CounterModule component.

This section describes the parameters.

Table 4-76 CounterModule parameters

Parameter	Allowed values	Default value	Description
`base_frequency`	-	`100000000`	Reset value for CNTFID0, base frequency in Hz.
`diagnostics`	`0x0`-`0x4`	`0x0`	Diagnostic verbosity.
`non_arch_fixed_frequency`	-	`0x0`	If set, ignore CNTFID0 and instead use this frequency in Hz.
`non_arch_start_at_default`	`true`, `false`	`false`	Firmware is expected to enable the timer at boot time. However, turning on this parameter is a model-specific method of enabling the CounterModule out of reset.
`readonly_is_WI`	`true`, `false`	`false`	Ignore, instead of failing, on writes to read-frame.
`use_real_time`	`true`, `false`	`false`	Update the GenericTimer counter at a real-time base frequency instead of simulator time.

This section describes the Timer component.

This section describes the parameters.

Table 4-77 Timer parameters

Parameter	Allowed values	Default value	Description
`diagnostics`	0-4	`0x0`	Diagnostic verbosity.
`frame_security`	-	''	Hard-wired, configurable security for frames, N/S/X, one character per timer frame.

Previous Next

Was this page helpful? Yes No