You copied the Doc URL to your clipboard.

APB slave interface signals

The APB slave interface processes several input and output APB signals.

The following table shows the signals that are used by the APB slave interface.

Table A-2 APB slave interface signals

Signal name Direction Source or destinationa Description
psel_s Input APB bridge

Slave select signal.

Indicates that the current transfer is intended for the Flash controller.

penable_s Input APB bridge

Strobe to time all accesses.

Indicates the start of the second cycle of an APB transfer.

paddr_s[12:0] Input APB bridge

Address bus. paddr_s[12] selects either the internal or an external register bank:

0 = Internal registers.

1 = External registers.

pstrb_s[3:0] Input APB bridge

Write strobe port. Each bit refers to a byte in the pwdata_s signal:

[3] pwdata_s[31:24].

[2] pwdata_s[23:16].

[1] pwdata_s[15:8].

[0] pwdata_s[7:0].

pwrite_s Input APB bridge APB transfer direction. Write only.
pwdata_s[31:0] Input APB bridge 32-bit write data bus.
prdata_s[31:0] Output APB bridge

32-bit read data bus.

Isolation and reset value = 0x00.

pready_s Output APB bridge

Driven LOW when extra wait states are required to complete access to the external registers.

Isolation and reset value = 0b0.

pslverr_s Output APB bridge

Driven HIGH when an error response is received from an access to the external registers.

Isolation and reset value = 0b0.

Note

APB signals that are not shown in the table are not used in GFC-100.
a The APB bridge is not supplied with GFC-100.
Was this page helpful? Yes No