You copied the Doc URL to your clipboard.

Disconnecting from a target

To disconnect from a target, you can use either the Debug Control or the Commands view.

  • If you are using the Debug Control view, click Disconnect from Target on the toolbar.

    Figure 5-15 Disconnecting from a target using the Debug Control view

    Disconnecting from a target using the Debug Control view

  • If you are using the Commands view, enter quit in the Command field, then click Submit.

    Figure 5-16 Disconnecting from a target using the Commands view

    Disconnecting from a target using the Commands view

The disconnection process ensures that the state of the target does not change, except for the following case:

  • Any downloads to the target are canceled and stopped.
  • Any breakpoints are cleared on the target, but are maintained in Arm® Development Studio.
  • The DAP (Debug Access Port) is powered down.
  • Debug bits in the DSC (Debug Status Control) register are cleared.

If a trace capture session is in progress, trace data continues to be captured even after Arm Development Studio has disconnected from the target.

Was this page helpful? Yes No