You copied the Doc URL to your clipboard.

Watchpoint Properties dialog box

Use the Watchpoint Properties dialog box to display the properties of a watchpoint.

You can:

  • View the Location at which the watchpoint is set.
  • View the memory Address at which the watchpoint is set.
  • View the Access Type of the watchpoint.
  • Enable or disable the watchpoint.
  • Set the Data Width.
  • Specify a Stop Condition.

Figure 15-60 Watchpoint Properties dialog box

Watchpoint Properties dialog box

Location

The data location at which the watchpoint is set.

Address

The memory address at which the watchpoint is set.

Access Type

The type of access specified for the watchpoint.

Enabled

Select to enable watchpoint, deselect to disable watchpoint.

Data Width

Specify the width to watch at the given address, in bits. Accepted values are: 8, 16, 32, and 64 if supported by the target. This parameter is optional.

The width defaults to:

  • 32 bits for an address.
  • The width corresponding to the type of the symbol or expression, if entered.
Stop Condition

Specify the condition which must evaluate to true at the time the watchpoint is triggered for the target to stop. Enter a C-style expression. For example, if your application code has a variable x, then you can specify: x == 10.

Note

You can create several conditional watchpoints, but when a conditional watchpoint is enabled, no other watchpoints (regardless of whether they are conditional) can be enabled.