You copied the Doc URL to your clipboard.

Debug Configurations - Connection tab

Use the Connection tab in the Debug Configurations dialog box to configure Arm® Debugger target connections. Each configuration that you create is associated with a single target processor or a cluster of architecturally similar processors (For example, a Symmetric Multi-Processing (SMP) configuration).

Figure 15-66 Connection tab

Connection tab

If the development platform has multiple processors that are architecturally different (For example, a Cortex®-A and Cortex-M), then you must create a separate configuration for each processor.

Note

  • Options in the Connection tab are dependent on the type of platform that you select.
  • When connecting to multiple targets, you cannot perform synchronization or cross-triggering operations.
Select target

These options enable you to select the target manufacturer, board, project type, and debug operation.

DTSL Options

Select Edit… to open a dialog box to configure additional debug and trace settings.

Target Connections

These options enable you to configure the connection between the debugger and the target:

RSE connection

A list of Remote Systems Explorer (RSE) configurations that you have previously set up. Select the required RSE configuration from the list.

Note

You must select an RSE connection to the target if your Linux application debug operation is:

  • Download and debug application
  • Start gdbserver and debug target-resident application.
gdbserver (TCP)

Specify the target IP address or name and the associated port number for the connection between the debugger and gdbserver.

The following options might also be available, depending on the debug operation you selected:

  • Select the Use Extended Mode checkbox if you want to restart an application under debug. Be aware that this might not be fully implemented by gdbserver on all targets.
  • Select the Terminate gdbserver on disconnect checkbox to terminate gdbserver when you disconnect from the target.

    Note

    Only available when the selected target is Connect to already running application.
  • Select the Use RSE Host checkbox to connect to gdbserver using the RSE configured host.
gdbserver (serial)

Specify the local serial port and connection speed for the serial connection between the debugger and gdbserver.

For model connections, details for gdbserver are obtained automatically from the target.

Select the Use Extended Mode option if you want to restart an application under debug. Be aware that this might not be fully implemented by gdbserver on all targets.

Bare Metal Debug

Specify the target IP address or name of the debug hardware adapter. You can also click on Browse… to display all the available debug hardware adapters on your local subnet or USB connections.

Model parameters

Specify the parameter for launching the model.

Apply

Save the current configuration. This does not connect to the target.

Revert

Undo any changes and revert to the last saved configuration.

Debug

Connect to the target and close the Debug Configurations dialog box.

Close

Close the Debug Configurations dialog box.

Was this page helpful? Yes No