Debug Hardware Configure IP view
Use the Debug Hardware Configure IP view to configure Ethernet and internet protocol settings on the debug hardware units connected to the host workstation.
The configuration process depends on how the debug hardware unit is connected to the host computer, and if your network uses Dynamic Host Configuration Protocol (DHCP). If your debug hardware unit is connected to an Ethernet network or is directly connected to the host computer using an Ethernet cross-over cable, you must configure the network settings before you can use the unit for debugging.
NoteYou have to configure the network settings once for each debug hardware unit.
The following connections are possible:
- Your debug hardware unit is connected to your local network that uses DHCP. For this method, you do not have to know the Ethernet address of the unit, but you must enable DHCP.
- Your debug hardware unit is connected to your local network that does not use DHCP. For this method, you must assign a static IP address to the debug hardware unit.
Figure 15-84 Debug Hardware Configure IP view
To access the Debug Hardware Configure IP view from the main menu, either:
- Select Window > Show View > Debug Hardware Configure IP.
- Select Window > Show View > Other... > Arm Debugger > Debug Hardware Configure IP.
Table 15-3 Debug Hardware Configure IP view contents
|Ethernet/MAC Address||The Ethernet address/media access control (MAC) address of the debug hardware unit. The address is automatically detected when you click Browse and select the hardware. To enter the value manually, select the Configure New option.|
|Browse…||Displays the Connection Browser dialog. Use it to browse and select the debug hardware unit in your local network, or one that is connected to a USB port on the host workstation.|
|Identify||Click to visually identify your debug hardware unit using the indicators available on the debug hardware. On DSTREAM, the DSTREAM logo flashes during identification.|
|Restart||Restarts the selected debug hardware unit.|
|Configure New||Select this option to manually configure a debug hardware unit that was not previously configured, or is on a different subnet.|
|Ethernet Type||Select the type of Ethernet you are connecting to. Auto-Detect is the default option. For DSTREAM devices, ensure that this is set to Auto-Detect.|
The following settings are available:
|Configure||Click to apply changes to the debug hardware unit.|