Use the Events view to view the output generated by the System Trace Macrocell (STM) and Instruction Trace Macrocell (ITM) events.
Data is captured from your application when it runs. However, no data appears in the Events view until you stop the application.
To stop the target, either click the Interrupt icon in the Debug Control view, or use the stop command in the Commands view. When your application stops, any captured logging information is automatically appended to the open views.
Figure 15-15 Events view (Shown with all ports enabled for an ETB:ITM trace source)
- Use the Event Viewer Settings dialog to select a Trace Source as well as to set up Ports (if ITM is the trace source) or Masters (if STM is the trace source) to display in the view.
- To view the Live Decode tab and streaming trace data, you must enable the Show live decode console option in the Event Viewer Settings dialog.