You copied the Doc URL to your clipboard.

Arm Cortex-M3 DesignStart FPGA-Xilinx edition User Guide : V2C-DAPLink board layout

V2C-DAPLink board layout

The V2C-DAPLink adaptor board layout is based on the Arduino Shield form factor.

The following figure shows the board layout.

Figure 5-2 V2C-DAPLink board layout


The optional V2C-DAPLink board features are supported on the inner row expansion pins. The shield adaptor pins pass through to a shield board above the optional V2C-DAPLink board.

The following table shows the Shield I/O pin mapping.

Table 5-2 Shield I/O mapping

I/O pin Artix 7 bank SPARTAN-7 bank V2C-DAPLink signal
26 14 14 SD_nSS
27 14 14 SD_MISO
28 14 14 SD_MOSI
29 14 14 SD_SCLK
30 14 14 QSPI_Q0
31 14 14 QSPI_Q1
32 14 14 QSPI_Q2
33 14 14 QSPI_Q3
34 CONFIG 14 RSVD (V2C-DAPLink fitted)
35 14 14 QSPI_CLK
36 14 14 QSPI_nS
37 14 CONFIG UART_RX
38 14 CONFIG UART_TX
39 14 CONFIG CS_nSRST
40 14 14 CS_DIO
41 14 14 CS_CLK
Was this page helpful? Yes No