You copied the Doc URL to your clipboard.

DSTREAM-PT system boot sequence

When you power up the DSTREAM-PT system, it goes through a boot sequence. The LEDs identify the progress of the boot sequence.

The boot sequence is:

  1. To indicate that both units are powered, the DSTREAM logo of the DSTREAM-ST unit illuminates blue and the STATUS LED of the Parallel Trace probe illuminates RED.

  2. The FLASH LED of the DSTREAM-ST unit flashes as it loads its firmware.

  3. The STATUS LED of the Parallel Trace probe illuminates green, indicating that its FPGA has successfully loaded.

  4. The STATUS LED of the DSTREAM-ST unit flashes green, and then stays illuminated, indicating that it has successfully booted.

  5. The Host Link LED of the Parallel Trace probe flashes blue, and then illuminates green to indicate that the units have successfully linked.

  6. If the target is connected to the DSTREAM-PT system and powered, the TARGET LED on the DSTREAM-ST unit and the VTREF LED on the Parallel Trace probe illuminate green.

The DSTREAM-PT unit is now ready for use.

Note

If your DSTREAM-PT system boot sequence does not follow this sequence, see Troubleshooting.

Was this page helpful? Yes No