The MBIST executes loaded instructions stored in the MBIST Instruction Register (MBIR). The MBIR is 59 bits wide and divided into a control unit part of 18 bits and a dispatch unit part of 41 bits.
The MBIR is loaded through serial port MBISTDATAIN of the control unit when MBISTSHIFT is asserted. When MBISTSHIFT is asserted again, the control unit passes MBISTDATAIN serially to the dispatch unit through its MBISTTX port.
Figure 3.1 shows the control unit part of the MBIR.
The control unit contains the following fields:
Specifies the test algorithm.
Specifies MBIST mode of operation and sticky or nonsticky fail flag.
- Write latency
Specifies the number of cycles to enable a RAM write.
- Read latency
Specifies the number of cycles to enable a RAM read.
Figure 3.2 shows the dispatch unit part of the MBIR.
The dispatch unit contains the following fields:
- CPU On
Controls the data comparison for the CPUs under test.
Specifies the number of bits in the X-address counter.
Specifies the number of bits in the Y-address counter.
Data seed to be used during test. These 4 bits are replicated 16 times to form 64 bits of data.
Specifies the RAM under test.
Specifies 4, 8, 16, or 32 columns per block of RAM.
Specifies a cache size of 16KB, 32KB, or 64KB.
Field descriptions describes the MBIR fields in more detail.