You copied the Doc URL to your clipboard.

3.2.1. Controlling ETM programming

When programming the ETM registers you must enable all the changes at the same time. For example, if the counter is reprogrammed, it might start to count based on incorrect events, before the trigger condition has been correctly set up.

You can use the ETM programming bit in the ETMCR to disable all trace operations during programming. See Main Control Register. To do this follow the procedure shown in Figure 3.1.

Figure 3.1. Programming ETM registers

Figure 3.1. Programming ETM registers

The processor does not have to be in the debug state while you program the ETM registers.