You copied the Doc URL to your clipboard.

13.8.39. Single-Shot Comparator Status Register 0

The TRCSSCSR0 characteristics are:

Purpose

Indicates the status of the single-shot comparator:

  • TRCSSCSR0 is sensitive to instruction addresses.

Usage constraints
  • Accepts writes only when the trace unit is disabled.

  • The STATUS bit value is stable only when TRCSTATR.PMSTABLE==1.

Configurations

Available in all configurations.

Attributes

See the register summary in Table 13.3.

Figure 13.41 shows the TRCSSCSR0 bit assignments.

Figure 13.41. TRCSSCSR0 bit assignments

Figure 13.41. TRCSSCSR0 bit assignments

Table 13.42 shows the TRCSSCSR0 bit assignments.

Table 13.42. TRCSSCSR0 bit assignments
BitsNameFunction
[31]STATUS

Single-shot status. This indicates whether any of the selected comparators have matched:

0

Match has not occurred.

1

Match has occurred at least once.

When programming the ETM trace unit, if TRCSSCCRn.RST is b0, the STATUS bit must be explicitly written to 0 to enable this single-shot comparator control.

[30:3]-Reserved, res0.
[2]DV

Data value comparator support:

0

Single-shot data value comparisons not supported.

[1]DA

Data address comparator support:

0

Single-shot data address comparisons not supported.

[0]INST

Instruction address comparator support:

1

Single-shot instruction address comparisons supported.


The TRCSSCSR0 can be accessed through the external debug interface, offset 0x2A0.

Was this page helpful? Yes No