You copied the Doc URL to your clipboard.

GICD_ICFGR<n>E, Interrupt Configuration Registers (Extended SPI Range), n = 0 - 63

The GICD_ICFGR<n>E characteristics are:

Purpose

Determines whether the corresponding SPI in the extended SPI range is edge-triggered or level-sensitive.

Configuration

RW fields in this register reset to architecturally UNKNOWN values.

This register is present only when GIC, >=3.1 is implemented. Otherwise, direct accesses to GICD_ICFGR<n>E are RES0.

When GICD_TYPER.ESPI==0, these registers are RES0.

When GICD_TYPER.ESPI==1, the number of implemented GICD_ICFGR<n>E registers is ((GICD_TYPER.ESPI_range+1)*2). Registers are numbered from 0.

Attributes

GICD_ICFGR<n>E is a 32-bit register.

Field descriptions

The GICD_ICFGR<n>E bit assignments are:

313029282726252423222120191817161514131211109876543210
Int_config<x>, bits [2x+1:2x], for x = 0 to 15

Int_config<x>, bits [2x+1:2x], for x = 0 to 15

Indicates whether the interrupt with ID 16n + x is level-sensitive or edge-triggered.

Int_config[0] (bit[2x]) is RES0.

Possible values of Int_config[1] (bit[2x+1]) are:

Int_config<x>Meaning
0b00

Corresponding interrupt is level-sensitive.

0b01

Corresponding interrupt is edge-triggered.

This field resets to an architecturally UNKNOWN value.

Accessing the GICD_ICFGR<n>E

When affinity routing is not enabled for the Security state of an interrupt in GICD_ICFGR<n>E, the corresponding bit is RES0.

When GICD_CTLR.DS==0, a register bit that corresponds to a Group 0 or Secure Group 1 interrupt is RAZ/WI to Non-secure accesses.

Bits corresponding to unimplemented interrupts are RAZ/WI.

GICD_ICFGR<n>E can be accessed through the memory-mapped interfaces:

ComponentOffsetInstance
GIC Distributor0x1E00 + 4nGICD_ICFGR<n>E

This interface is accessible as follows:

  • When GICD_CTLR.DS == 0b0 access to this register is RW.
  • When IsAccessSecure() access to this register is RW.
  • When !IsAccessSecure() access to this register is RW.


Was this page helpful? Yes No