You copied the Doc URL to your clipboard.

DC CVADP, Data or unified Cache line Clean by VA to PoDP

The DC CVADP characteristics are:

Purpose

Clean data cache by address to Point of Deep Persistence.

If the memory system does not identify a Point of Deep Persistence, then this instruction behaves as a DC CVAP.

When ARMv8.5-MemTag is implemented, this instruction might clean Allocation Tags from caches.

Configuration

This instruction is present only when ARMv8.2-DCCVADP is implemented. Otherwise, direct accesses to DC CVADP are UNDEFINED.

Attributes

DC CVADP is a 64-bit System instruction.

Field descriptions

The DC CVADP input value bit assignments are:

6362616059585756555453525150494847464544434241403938373635343332
Virtual address to use
Virtual address to use
313029282726252423222120191817161514131211109876543210

Bits [63:0]

Virtual address to use. No alignment restrictions apply to this VA.

Executing the DC CVADP instruction

If EL0 access is enabled, when executed at EL0, this instruction requires read access permission to the VA, otherwise it generates a Permission Fault, see 'Permission fault' in the Arm® Architecture Reference Manual, Armv8, for Armv8-A architecture profile.

Execution of this instruction might require an address translation from VA to PA, and that translation might fault. For more information, see 'The data cache maintenance instruction (DC)' in the Arm® Architecture Reference Manual, Armv8, for Armv8-A architecture profile.

Accesses to this instruction use the following encodings:

DC CVADP, <Xt>

op0op1CRnCRmop2
0b010b0110b01110b11010b001
if PSTATE.EL == EL0 then
    if !ELUsingAArch32(EL1) && !(EL2Enabled() && HCR_EL2.<E2H,TGE> == '11') && SCTLR_EL1.UCI == '0' then
        if EL2Enabled() && !ELUsingAArch32(EL2) && HCR_EL2.TGE == '1' then
            AArch64.SystemAccessTrap(EL2, 0x18);
        else
            AArch64.SystemAccessTrap(EL1, 0x18);
    elsif EL2Enabled() && !ELUsingAArch32(EL2) && HCR_EL2.<E2H,TGE> != '11' && HCR_EL2.TPCP == '1' then
        AArch64.SystemAccessTrap(EL2, 0x18);
    elsif EL2Enabled() && !ELUsingAArch32(EL2) && HCR_EL2.<E2H,TGE> == '11' && SCTLR_EL2.UCI == '0' then
        AArch64.SystemAccessTrap(EL2, 0x18);
    else
        DC_CVADP(X[t]);
elsif PSTATE.EL == EL1 then
    if EL2Enabled() && !ELUsingAArch32(EL2) && HCR_EL2.TPCP == '1' then
        AArch64.SystemAccessTrap(EL2, 0x18);
    else
        DC_CVADP(X[t]);
elsif PSTATE.EL == EL2 then
    DC_CVADP(X[t]);
elsif PSTATE.EL == EL3 then
    DC_CVADP(X[t]);
              


Was this page helpful? Yes No