DBGDTRTX_EL0, Debug Data Transfer Register, Transmit
The DBGDTRTX_EL0 characteristics are:
Transfers data from the PE to an external debugger. For example, it is used by a debug target to transfer data to the debugger. See DBGDTR_EL0 for additional architectural mappings. It is a component of the Debug Communication Channel.
External register DBGDTRTX_EL0 bits [31:0] are architecturally mapped to AArch64 System register DBGDTRRXint[31:0] .
External register DBGDTRTX_EL0 bits [31:0] are architecturally mapped to External register DBGDTRTXint[31:0] .
External register DBGDTRTX_EL0 bits [31:0] are architecturally mapped to AArch64 System register DBGDTRTXint[31:0] when written.
External register DBGDTRTX_EL0 bits [31:0] (read) are architecturally mapped to External register DBGDTRRXint[31:0] .
DBGDTRTX_EL0 is in the Core power domain. RW fields in this register reset to architecturally UNKNOWN values. These apply only on a Cold reset. The register is not affected by a Warm reset and is not affected by an External debug reset.
DBGDTRTX_EL0 is a 32-bit register.
The DBGDTRTX_EL0 bit assignments are:
Reads of this register:
If TXfull is set to 1, return the last value written to DTRTX.
If TXfull is set to 0, return an UNKNOWN value.
After the read, TXfull is cleared to 0.
Writes to this register:
If TXfull is set to 1, set DTRTX to UNKNOWN.
If TXfull is set to 0, update the value in DTRTX.
After the write, TXfull remains unchanged.
For the full behavior of the Debug Communications Channel, see The Debug Communication Channel and Instruction Transfer Register.
On a Cold reset, this field resets to an architecturally UNKNOWN value.
Accessing the DBGDTRTX_EL0
If EDSCR.ITE == 0 when the PE exits Debug state on receiving a Restart request trigger event, the behavior of any operation issued by a DTR access in memory access mode that has not completed execution is CONSTRAINED UNPREDICTABLE, and must do one of the following:
- It must complete execution in Debug state before the PE executes the restart sequence.
- It must complete execution in Non-debug state before the PE executes the restart sequence.
- It must be abandoned. This means that the instruction does not execute. Any registers or memory accessed by the instruction are left in an UNKNOWN state.
DBGDTRTX_EL0 can be accessed through the external debug interface:
This interface is accessible as follows:
- When IsCorePowered(), !DoubleLockStatus(), !OSLockStatus() and SoftwareLockStatus() access to this register is RO.
- When IsCorePowered(), !DoubleLockStatus(), !OSLockStatus() and !SoftwareLockStatus() access to this register is RW.
- Otherwise access to this register returns an Error.