You copied the Doc URL to your clipboard.

GICR_ISACTIVER<n>E, Interrupt Set-Active Registers, n = 1 - 2

The GICR_ISACTIVER<n>E characteristics are:

Purpose

Adds the active state to the corresponding PPI.

Configuration

RW fields in this register reset to architecturally UNKNOWN values.

This register is present only when GIC, >=3.1 is implemented. Otherwise, direct accesses to GICR_ISACTIVER<n>E are RES0.

A copy of this register is provided for each Redistributor.

Attributes

GICR_ISACTIVER<n>E is a 32-bit register.

Field descriptions

The GICR_ISACTIVER<n>E bit assignments are:

313029282726252423222120191817161514131211109876543210
Set_active_bit<x>, bit [x], for x = 0 to 31

Set_active_bit<x>, bit [x], for x = 0 to 31

For the extended PPIs, adds the active state to interrupt number x. Reads and writes have the following behavior:

Set_active_bit<x>Meaning
0b0

If read, indicates that the corresponding interrupt is not active, and is not active and pending.

If written, has no effect.

0b1

If read, indicates that the corresponding interrupt is active, or active and pending on this PE.

If written, activates the corresponding interrupt, if the interrupt is not already active. If the interrupt is already active, the write has no effect.

After a write of 1 to this bit, a subsequent read of this bit returns 1.

This field resets to an architecturally UNKNOWN value.

For INTID m, when DIV and MOD are the integer division and modulo operations:

  • The corresponding GICR_ISACTIVER<n>E number, n, is given by n = (m-1024) DIV 32.
  • The offset of the required GICR_ISACTIVER<n>E is (0x200 + (4*n)).
  • The bit number of the required group modifier bit in this register is (m-1024) MOD 32.

Accessing the GICR_ISACTIVER<n>E

When affinity routing is not enabled for the Security state of an interrupt in GICR_ISACTIVER<n>E, the corresponding bit is RES0.

When GICD_CTLR.DS==0, bits corresponding to Secure PPIs are RAZ/WI to Non-secure accesses.

Bits corresponding to unimplemented interrupts are RAZ/WI.

GICR_ISACTIVER<n>E can be accessed through the memory-mapped interfaces:

ComponentFrameOffsetInstance
GIC RedistributorSGI_base0x0300 + 4nGICR_ISACTIVER<n>E

This interface is accessible as follows:

  • When GICD_CTLR.DS == 0b0 access to this register is RW.
  • When IsAccessSecure() access to this register is RW.
  • When !IsAccessSecure() access to this register is RW.


Was this page helpful? Yes No