You copied the Doc URL to your clipboard.

MSMON_CFG_MON_SEL, MPAM Partion Configuration Selection Register

The MSMON_CFG_MON_SEL characteristics are:

Purpose

Selects a monitor to access the configuration or counter.

Note

Different performance monitoring features within a MSC could have different numbers of monitors. See the feature's NUM_MON field in its ID register. Thus, a monitor out-of-bounds error might be signaled when an MSMON_CFG register is accessed because the value in MSMON_CFG_MON_SEL.MON_SEL is too large for the particular monitoring feature.

To configure a monitor, set MON_SEL in this register to the index of the monitor chosen, then write to the MSMON_CFG_x register to set the configuration of the monitor. At a later time, read the monitor register (for example MSMON_MBWU) to get the value of the monitor.

Configuration

The power domain of MSMON_CFG_MON_SEL is IMPLEMENTATION DEFINED.

This register is present only when MPAMF_IDR.HAS_MSMON == 1 or MPAMF_IDR.HAS_IMPL_IDR == 1. Otherwise, direct accesses to MSMON_CFG_MON_SEL are IMPLEMENTATION DEFINED.

Attributes

MSMON_CFG_MON_SEL is a 32-bit register.

Field descriptions

The MSMON_CFG_MON_SEL bit assignments are:

313029282726252423222120191817161514131211109876543210
RES0MON_SEL

Bits [31:8]

Reserved, RES0.

MON_SEL, bits [7:0]

Selects the monitor to configure or read.

Reads and writes to other MSMON registers are indexed by MON_SEL and by the NS bit used to access MSMON_CFG_MON_SEL to access the configuration for a single monitor.

Accessing the MSMON_CFG_MON_SEL

This register is part of the MPAMF_BASE memory frame. In a system that supports Secure and Non-secure memory maps, the MPAMF_BASE frame must be accessible in both Secure and Non-secure memory address maps.

MSMON_CFG_MON_SEL must be accessible from the Non-secure and Secure address maps.

MSMON_CFG_MON_SEL must be banked for the Secure and Non-secure address maps. The Secure instance is used with accesses to other MSMON registers to configure monitors for Secure PARTIDs, and the Non-secure instance is used with accesses to other MSMON registers to configure monitors for Non-secure PARTIDs.

MSMON_CFG_MON_SEL can be accessed through the memory-mapped interfaces:

ComponentFrameOffsetInstance
MPAM.anyMPAMF_BASE_s0x0800MSMON_CFG_MON_SEL_s

Access on this interface is RW.

ComponentFrameOffsetInstance
MPAM.anyMPAMF_BASE_ns0x0800MSMON_CFG_MON_SEL_ns

Access on this interface is RW.



Was this page helpful? Yes No