ATS1CPR, Address Translate Stage 1 Current state PL1 Read
The ATS1CPR characteristics are:
Purpose
Performs stage 1 address translation as defined for PL1 and the current Security state, with permissions as if reading from the given virtual address.
Configuration
This instruction is present only when AArch32 is supported at any Exception level. Otherwise, direct accesses to ATS1CPR are UNDEFINED.
Attributes
ATS1CPR is a 32-bit System instruction.
Field descriptions
The ATS1CPR input value bit assignments are:
31 | 30 | 29 | 28 | 27 | 26 | 25 | 24 | 23 | 22 | 21 | 20 | 19 | 18 | 17 | 16 | 15 | 14 | 13 | 12 | 11 | 10 | 9 | 8 | 7 | 6 | 5 | 4 | 3 | 2 | 1 | 0 |
Input address for translation |
Bits [31:0]
Input address for translation. The resulting address can be read from the PAR.
This System instruction takes a VA as input. If EL2 is implemented and enabled in the current Security state, the resulting address is the IPA that is the output address of the stage 1 translation. Otherwise, the resulting address is a PA.
Executing the ATS1CPR instruction
Accesses to this instruction use the following encodings:
MCR{<c>}{<q>} <coproc>, {#}<opc1>, <Rt>, <CRn>, <CRm>{, {#}<opc2>}
coproc | opc1 | CRn | CRm | opc2 |
---|---|---|---|---|
0b1111 | 0b000 | 0b0111 | 0b1000 | 0b000 |
if PSTATE.EL == EL0 then UNDEFINED; elsif PSTATE.EL == EL1 then if EL2Enabled() && !ELUsingAArch32(EL2) && HSTR_EL2.T7 == '1' then AArch64.AArch32SystemAccessTrap(EL2, 0x03); elsif EL2Enabled() && ELUsingAArch32(EL2) && HSTR.T7 == '1' then AArch32.TakeHypTrapException(0x03); else ATS1CPR(R[t]); elsif PSTATE.EL == EL2 then ATS1CPR(R[t]); elsif PSTATE.EL == EL3 then ATS1CPR(R[t]);