GICC_HPPIR, CPU Interface Highest Priority Pending Interrupt Register
The GICC_HPPIR characteristics are:
Provides the INTID of the highest priority pending interrupt on the CPU interface.
- This register is Common.
- GICC_AHPPIR is an alias of the Non-secure view of this register.
GICC_HPPIR is a 32-bit register.
The GICC_HPPIR bit assignments are:
INTID, bits [23:0]
The INTID of the signaled interrupt.
INTIDs 1020-1023 are reserved and convey additional information such as spurious interrupts.
When affinity routing is not enabled:
- Bits [23:13] are RES0.
- For SGIs, bits [12:10] identify the CPU interface corresponding to the source PE. For all other interrupts these bits are RES0.
Accessing the GICC_HPPIR
This register is used only when System register access is not enabled. When System register access is enabled:
- For AArch32 implementations, ICC_HPPIR0 and ICC_HPPIR1 provide equivalent functionality.
- For AArch64 implementations, ICC_HPPIR0_EL1 and ICC_HPPIR1_EL1 provide equivalent functionality.
If the highest priority pending interrupt is in Group 0, a Non-secure read of this register returns the special INTID 1023.
If no interrupts are in the pending state, a read of this register returns the special INTID 1023.
Interrupt identifiers corresponding to an interrupt group that is not enabled are ignored.
If the highest priority pending interrupt is a direct interrupt that is both individually enabled in the Distributor and part of an interrupt group that is enabled in the Distributor, and the interrupt group is disabled in the CPU interface for this PE, this register returns the special INTID 1023.
For more information about pending interrupts that are not considered when determining the highest priority pending interrupt, see 'Preemption' in ARM® Generic Interrupt Controller Architecture Specification, GIC architecture version 3.0 and version 4.0 (ARM IHI 0069).
When affinity routing is enabled for a Security state, it is a programming error to use memory-mapped registers to access the GIC.
GICC_HPPIR can be accessed through the memory-mapped interfaces:
|GIC CPU interface||0x0018||GICC_HPPIR|
This interface is accessible as follows:
- When GICD_CTLR.DS == 0 accesses to this register are RO.
- When an access is Secure accesses to this register are RO.
- When an access is Non-secure accesses to this register are RO.