GICR_ISPENDR<n>E, Interrupt Set-Pending Registers, n = 1 - 2
The GICR_ISPENDR<n>E characteristics are:
Adds the pending state to the corresponding PPI.
This register is present only when FEAT_GICv3p1 is implemented. Otherwise, direct accesses to GICR_ISPENDR<n>E are RES0.
A copy of this register is provided for each Redistributor.
GICR_ISPENDR<n>E is a 32-bit register.
The GICR_ISPENDR<n>E bit assignments are:
|Set_pending_bit<x>, bit [x], for x = 0 to 31|
Set_pending_bit<x>, bit [x], for x = 0 to 31
For the extended PPIs, adds the pending state to interrupt number x. Reads and writes have the following behavior:
If read, indicates that the corresponding interrupt is not pending on this PE.
If written, has no effect.
If read, indicates that the corresponding interrupt is pending, or active and pending on this PE.
If written, changes the state of the corresponding interrupt from inactive to pending, or from active to active and pending.
This has no effect in the following cases:
This field resets to an architecturally UNKNOWN value.
For INTID m, when DIV and MOD are the integer division and modulo operations:
- The corresponding GICR_ISPENDR<n>E number, n, is given by n = (m-1024) DIV 32.
- The offset of the required GICR_ISPENDR<n>E is (0x200 + (4*n)).
- The bit number of the required group modifier bit in this register is (m-1024) MOD 32.
Accessing the GICR_ISPENDR<n>E
When affinity routing is not enabled for the Security state of an interrupt in GICR_ISPENDR<n>E, the corresponding bit is RES0.
When GICD_CTLR.DS==0, bits corresponding to Secure PPIs are RAZ/WI to Non-secure accesses.
Bits corresponding to unimplemented interrupts are RAZ/WI.
GICR_ISPENDR<n>E can be accessed through the memory-mapped interfaces:
|GIC Redistributor||SGI_base||0x0200 + (4 * n)||GICR_ISPENDR<n>E|
This interface is accessible as follows:
- When GICD_CTLR.DS == 0 accesses to this register are RW.
- When an access is Secure accesses to this register are RW.
- When an access is Non-secure accesses to this register are RW.