TLBIASID, TLB Invalidate by ASID match

The TLBIASID characteristics are:

Purpose

Invalidate all cached copies of translation table entries from TLBs that meet the following requirements:

• The entry is a stage 1 translation table entry.
• The entry would be used for the specified ASID, and either:
  • Is from a level of lookup above the final level.
  • Is a non-global entry from the final level of lookup.
• If EL2 is implemented and enabled in the current Security state, the entry would be used with the current VMID.

From the entries that match these requirements, the entries that are invalidated are required for the following translation regime:

• If executed at Secure EL1 when EL3 is using AArch64, the Secure EL1&0 translation regime.
• If executed in Secure state when EL3 is using AArch32, the Secure PL1&0 translation regime.
• If executed in Non-secure state, the Non-secure PL1&0 translation regime.

The invalidation only applies to the PE that executes this System instruction.

Configuration

This instruction is present only when AArch32 is supported at any Exception level. Otherwise, direct accesses to TLBIASID are UNDEFINED.

Attributes

TLBIASID is a 32-bit System instruction.

Field descriptions

The TLBIASID input value bit assignments are:

Bits [31:8]

Reserved, RES0.

ASID, bits [7:0]

ASID value to match. Any TLB entries for non-global pages that match the ASID values will be affected by this System instruction.

if PSTATE.EL == EL0 then
    UNDEFINED;
elsif PSTATE.EL == EL1 then
    if EL2Enabled() && !ELUsingAArch32(EL2) && HSTR_EL2.T8 == '1' then
        AArch64.AArch32SystemAccessTrap(EL2, 0x03);
    elsif EL2Enabled() && ELUsingAArch32(EL2) && HSTR.T8 == '1' then
        AArch32.TakeHypTrapException(0x03);
    elsif EL2Enabled() && !ELUsingAArch32(EL2) && HCR_EL2.TTLB == '1' then
        AArch64.AArch32SystemAccessTrap(EL2, 0x03);
    elsif EL2Enabled() && ELUsingAArch32(EL2) && HCR.TTLB == '1' then
        AArch32.TakeHypTrapException(0x03);
    elsif EL2Enabled() && ELUsingAArch32(EL2) && HCR.FB == '1' then
        TLBIASIDIS(R[t]);
    else
        TLBIASID(R[t]);
elsif PSTATE.EL == EL2 then
    TLBIASID(R[t]);
elsif PSTATE.EL == EL3 then
    TLBIASID(R[t]);