You copied the Doc URL to your clipboard.


Atomic unsigned minimum on byte in memory atomically loads an 8-bit byte from memory, compares it against the value held in a register, and stores the smaller value back to memory, treating the values as unsigned numbers. The value initially loaded from memory is returned in the destination register.

  • If the destination register is not WZR, LDUMINAB and LDUMINALB load from memory with acquire semantics.
  • LDUMINLB and LDUMINALB store to memory with release semantics.
  • LDUMINB has no memory ordering requirements.

For more information about memory ordering semantics see Load-Acquire, Store-Release.

For information about memory accesses see Load/Store addressing modes.

This instruction is used by the alias STUMINB, STUMINLB.



LDUMINAB (A == 1 && R == 0)

LDUMINAB <Ws>, <Wt>, [<Xn|SP>]

LDUMINALB (A == 1 && R == 1)

LDUMINALB <Ws>, <Wt>, [<Xn|SP>]

LDUMINB (A == 0 && R == 0)

LDUMINB <Ws>, <Wt>, [<Xn|SP>]

LDUMINLB (A == 0 && R == 1)

LDUMINLB <Ws>, <Wt>, [<Xn|SP>]

if !HaveAtomicExt() then UNDEFINED;
integer t = UInt(Rt);
integer n = UInt(Rn);
integer s = UInt(Rs);

AccType ldacctype = if A == '1' && Rt != '11111' then AccType_ORDEREDATOMICRW else AccType_ATOMICRW;
AccType stacctype = if R == '1' then AccType_ORDEREDATOMICRW else AccType_ATOMICRW;
boolean tag_checked = n != 31;

Assembler Symbols


Is the 32-bit name of the general-purpose register holding the data value to be operated on with the contents of the memory location, encoded in the "Rs" field.


Is the 32-bit name of the general-purpose register to be loaded, encoded in the "Rt" field.


Is the 64-bit name of the general-purpose base register or stack pointer, encoded in the "Rn" field.

Alias Conditions

AliasIs preferred when
STUMINB, STUMINLBA == '0' && Rt == '11111'


bits(64) address;
bits(8) value;
bits(8) data;
bits(8) result;

if HaveMTEExt() then

value = X[s];
if n == 31 then
    address = SP[];
    address = X[n];

// All observers in the shareability domain observe the
// following load and store atomically.
data = Mem[address, 1, ldacctype];

result = if UInt(data) > UInt(value) then value else data;

Mem[address, 1, stacctype] = result;

if t != 31 then
    X[t] = ZeroExtend(data, 32);

Operational information

If PSTATE.DIT is 1, the timing of this instruction is insensitive to the value of the data being loaded or stored.

Was this page helpful? Yes No