You copied the Doc URL to your clipboard.

ADD, ADDS (register-shifted register)

Add (register-shifted register) adds a register value and a register-shifted register value. It writes the result to the destination register, and can optionally update the condition flags based on the result.

A1

313029282726252423222120191817161514131211109876543210
!= 11110000100SRnRdRs0type1Rm
cond

Flag setting (S == 1)

ADDS{<c>}{<q>} {<Rd>,} <Rn>, <Rm>, <type> <Rs>

Not flag setting (S == 0)

ADD{<c>}{<q>} {<Rd>,} <Rn>, <Rm>, <type> <Rs>

d = UInt(Rd);  n = UInt(Rn);  m = UInt(Rm);  s = UInt(Rs);
setflags = (S == '1');  shift_t = DecodeRegShift(type);
if d == 15 || n == 15 || m == 15 || s == 15 then UNPREDICTABLE;

For more information about the constrained unpredictable behavior, see Architectural Constraints on UNPREDICTABLE behaviors.

Assembler Symbols

<c>

See Standard assembler syntax fields.

<q>

See Standard assembler syntax fields.

<Rd>

Is the general-purpose destination register, encoded in the "Rd" field.

<Rn>

Is the first general-purpose source register, encoded in the "Rn" field.

<Rm>

Is the second general-purpose source register, encoded in the "Rm" field.

<type> Is the type of shift to be applied to the second source register, encoded in type:
type <type>
00 LSL
01 LSR
10 ASR
11 ROR
<Rs>

Is the third general-purpose source register holding a shift amount in its bottom 8 bits, encoded in the "Rs" field.

Operation

if ConditionPassed() then
    EncodingSpecificOperations();
    shift_n = UInt(R[s]<7:0>);
    shifted = Shift(R[m], shift_t, shift_n, PSTATE.C);
    (result, nzcv) = AddWithCarry(R[n], shifted, '0');
    R[d] = result;
    if setflags then
        PSTATE.<N,Z,C,V> = nzcv;

Operational information

If CPSR.DIT is 1, this instruction has passed its condition execution check, and does not use R15 as either its source or destination:

  • The execution time of this instruction is independent of:
    • The values of the data supplied in any of its registers.
    • The values of the NZCV flags.
  • The response of this instruction to asynchronous exceptions does not vary based on:
    • The values of the data supplied in any of its registers.
    • The values of the NZCV flags.
Was this page helpful? Yes No