You copied the Doc URL to your clipboard.

ITLBIALL, Instruction TLB Invalidate All

The ITLBIALL characteristics are:


Invalidate all cached copies of translation table entries from instruction TLBs that are from any level of the translation table walk. The entries that are invalidated are as follows:

  • If executed at EL1, all entries that:
    • Would be required for the EL1&0 translation regime.
    • Match the current VMID, if EL2 is implemented and enabled in the current Security state.
  • If executed in Secure state when EL3 is using AArch32, all entries that would be required for the Secure PL1&0 translation regime.
  • If executed at EL2, the stage 1 or stage 2 translation table entries that would be required for the Non-secure PL1&0 translation regime and matches the current VMID.

The invalidation only applies to the PE that executes this System instruction.

Arm deprecates the use of this System instruction. It is only provided for backwards compatibility with earlier versions of the Arm architecture.



ITLBIALL is a 32-bit System instruction.

Field descriptions

ITLBIALL ignores the value in the register specified by the instruction encoding. Software does not have to write a value to the register before issuing this instruction.

Executing the ITLBIALL instruction

Accesses to this instruction use the following encodings:

MCR{<c>}{<q>} <coproc>, {#}<opc1>, <Rt>, <CRn>, <CRm>{, {#}<opc2>}

if PSTATE.EL == EL0 then
elsif PSTATE.EL == EL1 then
    if EL2Enabled() && !ELUsingAArch32(EL2) && HSTR_EL2.T8 == '1' then
        AArch64.AArch32SystemAccessTrap(EL2, 0x03);
    elsif EL2Enabled() && ELUsingAArch32(EL2) && HSTR.T8 == '1' then
    elsif EL2Enabled() && !ELUsingAArch32(EL2) && HCR_EL2.TTLB == '1' then
        AArch64.AArch32SystemAccessTrap(EL2, 0x03);
    elsif EL2Enabled() && !ELUsingAArch32(EL2) && HCR.TTLB == '1' then
elsif PSTATE.EL == EL2 then
elsif PSTATE.EL == EL3 then