You copied the Doc URL to your clipboard.

TLBIALL, TLB Invalidate All

The TLBIALL characteristics are:

Purpose

Invalidate all cached copies of translation table entries from TLBs that are from any level of the translation table walk. The entries that are invalidated are as follows:

  • If executed at EL1, all entries that:
    • Would be required for the EL1&0 translation regime.
    • Match the current VMID, if EL2 is implemented and enabled in the current Security state.
  • If executed in Secure state when EL3 is using AArch32, all entries that would be required for the Secure PL1&0 translation regime.
  • If executed at EL2, and if EL2 is enabled in the current Security state, the stage 1 or stage 2 translation table entries that would be required for the PL1&0 translation regime and matches the current VMID.

The invalidation only applies to the PE that executes this System instruction.

Configuration

This instruction is present only when AArch32 is supported at any Exception level. Otherwise, direct accesses to TLBIALL are UNKNOWN.

Attributes

TLBIALL is a 32-bit System instruction.

Field descriptions

TLBIALL ignores the value in the register specified by the instruction encoding. Software does not have to write a value to the register before issuing this instruction.

Executing the TLBIALL instruction

Accesses to this instruction use the following encodings:

MCR{<c>}{<q>} <coproc>, {#}<opc1>, <Rt>, <CRn>, <CRm>{, {#}<opc2>}

coprocopc1CRnCRmopc2
0b11110b0000b10000b01110b000
if PSTATE.EL == EL0 then
    UNDEFINED;
elsif PSTATE.EL == EL1 then
    if EL2Enabled() && !ELUsingAArch32(EL2) && HSTR_EL2.T8 == '1' then
        AArch64.AArch32SystemAccessTrap(EL2, 0x03);
    elsif EL2Enabled() && ELUsingAArch32(EL2) && HSTR.T8 == '1' then
        AArch32.TakeHypTrapException(0x03);
    elsif EL2Enabled() && !ELUsingAArch32(EL2) && HCR_EL2.TTLB == '1' then
        AArch64.AArch32SystemAccessTrap(EL2, 0x03);
    elsif EL2Enabled() && ELUsingAArch32(EL2) && HCR.TTLB == '1' then
        AArch32.TakeHypTrapException(0x03);
    elsif EL2Enabled() && ELUsingAArch32(EL2) && HCR.FB == '1' then
        TLBIALLIS();
    else
        TLBIALL();
elsif PSTATE.EL == EL2 then
    TLBIALL();
elsif PSTATE.EL == EL3 then
    TLBIALL();
              


Was this page helpful? Yes No