You copied the Doc URL to your clipboard.

A.4. Logic analyzer connector

A Mictor-type logic analyzer connector is provided. It connects to the B[31:0] signals used for GPIO B. If particular signals must be connected to a logic analyzer, the FPGA configuration can be changed to reassign the signal connections.

If the FPGA configuration is changed to reassign signal connections, the GPIO B connections on connector J16 also change.

Figure A.4 shows the pin numbers of this type of connector.

Figure A.4. J7 pin locations

J7 pin locations

Table A.4 shows the pinout of the logic analyzer connector.

J7 connector pinout
SignalPinPinSignal
No connect12No connect
GND34No connect
SYSCLK56CLK_1
B3178B15
B30910B14
B291112B13
B281314B12
B271516B11
B261718B10
B251920B9
B242122B8
B232324B7
B222526B6
B212728B5
B202930B4
B193132B3
B183334B2
B173536B1
B163738B0
Was this page helpful? Yes No