You copied the Doc URL to your clipboard.

3.9. GPIO interface

The GPIO signals GP0[7:0] and GP1[7:0] from the ARM926PXP development chip are connected to the interface connector as shown in Figure 3.22. This enables you to use the GPIO signals with custom logic you implement in an interface board.

See also General Purpose Input/Output, GPIO, the ARM926EJ-S Development Chip Reference Manual and the ARM PrimeCell GPIO (PL061) Technical Reference Manual.

Figure 3.22. GPIO block diagram

GPIO block diagram

Note

The GPIO signals GP2_[3:0] are connected to the boot select switch S4.

GP2_[4] is HIGH if an interface board is connected.

GP2_[6:5] go to the battery pack connector.

There are no external connections for GP3 from the ARM926PXP development chip.

Was this page helpful? Yes No