Auto Refresh Properties dialog box
Describes the dialog box content.
The dialog box enables you to modify the update intervals settings.
- Refresh Off/Blocked
Enables you to modify the stop/block auto refresh.
- Update Interval
Specifies the auto refresh interval in seconds.
- Update When
Enables you to specify when you want auto refresh to update:
Refreshes the Memory view while the target is running.
Refreshes the Memory view while the target is stopped.
Always refreshes the Memory view.
When using the
Always selections, the Memory and Screen views are only updated if the target supports access to that memory when running. For
example, some CoreSight™ targets support access to physical memory at any time via the Debug Access Port (DAP) to the Advanced High-performance Bus Access Port (AHB-AP) bridge. In those cases, add the
AHB: prefix to the address selected in the Memory or Screen views. This type of access bypasses any
cache on the CPU core, so the memory content returned might be different to the value that the core reads.
Figure 10-25 Auto Refresh properties dialog box