You copied the Doc URL to your clipboard.

DTSL Configuration Editor dialog box

Describes the dialog box content.

The Debug and Trace Services Layer (DTSL) configuration editor enables you to configure additional debug and trace settings. The available configuration options depend on the capabilities of the target, and typically enable configuration of the trace collection method and the trace that is generated. A typical set of configuration options might include:

Trace capture method

Select the collection method that you want to use for this debug configuration. The available trace collection methods depend on the target and trace capture unit but can include Embedded Trace Buffer (ETB)/Micro Trace Buffer (MTB) (trace collected from an on-chip buffer) or DSTREAM™ (trace collected from the DSTREAM trace buffer). If no trace collection method is selected then no trace can be collected, even if the trace capture for processors and Instruction Trace Macrocell (ITM) are enabled.

Enable core trace

Enable or disable trace collection. If enabled then the following options are available:

Enable core n trace

Specify trace capture for specific processors.

Cycle accurate

Enable or disable cycle accurate trace.

Trace capture range

Specify an address range to limit the trace capture.

Enable ITM trace

Enable or disable trace collection from the ITM unit.

Named DTSL configuration profiles can be saved for later use.

Figure 10-45 DTSL configuration editor

DTSL configuration editor