You copied the Doc URL to your clipboard.

Watchpoint Properties dialog box

Use the Watchpoint Properties dialog box to display the properties of a watchpoint and to change the watchpoint type.

Figure 10-38 Watchpoint Properties dialog box

Watchpoint Properties dialog box

The following types are available:

READ

The debugger stops the target when the address is read from.

WRITE

The debugger stops the target when the address is written to.

ACCESS

The debugger stops the target when the address is read from or written to.

The following properties are displayed:

State

Indicates whether the watchpoint is valid or invalid. A watchpoint is invalid if it cannot be set for any reason. Typically this is because hardware resources have run out.

Enabled

Indicates whether the watchpoint is enabled or disabled.

Hardware Virtualization

Indicates whether Hardware Virtualization is supported.

Break on Virtual Machine ID

If Hardware Virtualization is supported, specify the Virtual Machine ID (VMID) of the guest operating system to which the watchpoint applies.