This command controls the automatic behavior of breakpoints and watchpoints.
set breakpoint [
Specifies additional options:
Controls the automatic breakpoint selection when using the
Disables automatic breakpoint selection.
Uses the memory map attributes to decide if hardware or software breakpoints must be used. This is the default.
Controls the automatic removal of breakpoints and watchpoints when disconnecting from the target:
Disables automatic removal.
Enables automatic removal. This is the default.
If the target is running, the debugger temporarily stops the target before removing breakpoints and watchpoints.
Controls whether to skip all breakpoints and watchpoints:
Disables skip mode. This is the default.
Enables skip mode.