You copied the Doc URL to your clipboard.

set step-mode

This command controls the default behavior of the step and steps commands.

Syntax

set step-mode { step-over | stop | step-until-source}

Where:

step-over

If the instruction is a function call then the debugger performs a step-over. Otherwise, it stops. This is the default.

stop

The debugger stops when execution reaches an address with no source.

step-until-source

The debugger performs steps until it reaches source. To speed up the execution, the debugger might use abstract interpretation and break or run until the line of source is reached.

Example

set step-mode step-over             # Step over a function call and stop.
                                    # Otherwise stop