You copied the Doc URL to your clipboard.

An example ARM assembly language module

Example 7 illustrates some of the core constituents of an assembly language module. The example is written in ARM assembly language.

The constituent parts of this example are:

  • ELF sections (defined by the AREA directive)

  • application entry (defined by the ENTRY directive)

  • application execution

  • application termination

  • program end (defined by the END directive).

Example 7 defines a single section called ARMex that contains code and is marked as being READONLY.

        AREA     ARMex, CODE, READONLY
                                ; Name this block of code ARMex
        ENTRY                   ; Mark first instruction to execute
start
        MOV      r0, #10        ; Set up parameters
        MOV      r1, #3
        ADD      r0, r0, r1     ; r0 = r0 + r1
stop
        MOV      r0, #0x18      ; angel_SWIreason_ReportException
        LDR      r1, =0x20026   ; ADP_Stopped_ApplicationExit
        SVC      #0x123456      ; ARM semihosting (formerly SWI)
        END                     ; Mark end of file

Application entry

The ENTRY directive declares an entry point to the program. It marks the first instruction to be executed. In applications using the C library, an entry point is also contained within the C library initialization code. Initialization code and exception handlers also contain entry points.

Application execution

The application code in Example 7 begins executing at the label start, where it loads the decimal values 10 and 3 into registers R0 and R1. These registers are added together and the result placed in R0.

Application termination

After executing the main code, the application terminates by returning control to the debugger. This is done using the ARM semihosting SVC (0x123456 by default), with the following parameters:

  • R0 equal to angel_SWIreason_ReportException (0x18)

  • R1 equal to ADP_Stopped_ApplicationExit (0x20026).

Program end

The END directive instructs the assembler to stop processing this source file. Every assembly language source module must finish with an END directive on a line by itself. Any lines following the END directive are ignored by the assembler.

See also

Concepts

Developing Software for ARM processors:

Reference

Assembler Reference:

Was this page helpful? Yes No