You copied the Doc URL to your clipboard.

Load addresses to a register using ADRL

The ADRL pseudo-instruction enables you to generate an address, within a certain range, without performing a data load. ADRL accepts a PC-relative expression, that is, a label with an optional offset where the address of the label is relative to the current PC.

Note

The label used with ADRL must be within the same code section. The assembler faults references to labels that are out of range in the same section.

ADRL is not available in Thumb state on processors before ARMv6T2.

The assembler converts an ADRL rn,label pseudo-instruction by generating:

  • two data processing instructions that load the address, if it is in range

  • an error message if the address cannot be constructed in two instructions.

The available range depends on the instruction set in use:

ARM

Any value that can be generated by two ADD or two SUB instructions. That is, any value that can be produced by the addition of two values, each of which is 8 bits rotated right by any even number of bits within a 32-bit word. The range is relative to the PC.

32-bit Thumb

±1MB to a byte, halfword, or word-aligned address.

16-bit Thumb

ADRL is not available.

Was this page helpful? Yes No