You copied the Doc URL to your clipboard.

Condition codes

Instructions that can be conditional have an optional two character condition code suffix.

Condition codes are shown in syntax descriptions as {cond}. The following table shows the condition codes that you can use:

Table 10-2 Condition code suffixes

Suffix Meaning
EQ Equal
NE Not equal
CS Carry set (identical to HS)
HS Unsigned higher or same (identical to CS)
CC Carry clear (identical to LO)
LO Unsigned lower (identical to CC)
MI Minus or negative result
PL Positive or zero result
VS Overflow
VC No overflow
HI Unsigned higher
LS Unsigned lower or same
GE Signed greater than or equal
LT Signed less than
GT Signed greater than
LE Signed less than or equal
AL Always (this is the default)

Note

The meanings of the condition codes depend on whether the condition flags were set by a VFP instruction or by an ARM data processing instruction.

Was this page helpful? Yes No